Operating Instructions - Schumacher Electric PI-200 Manual Del Propietário

ATTENTION: Failure to make the correct connections
will result in blown fuses and permanent damage to the
inverter.
6.

OPERATING INSTRUCTIONS

1. Connect the inverter (see "CONNECTING INVERT-
ER CABLES" section.
2. Switch the inverter switch to the ON (I) position.
3. The LED indicator light should glow GREEN verify-
ing the inverter is receiving power.
4. Turn the inverter rocker switch to the OFF (O) posi-
tion. (The GREEN LED power indicator light may flash
briefly and/or the internal speaker may make a brief
"beep". This is normal.).
5. Make sure the device to be operated is turned OFF.
6. Plug the device into the inverter AC outlet.
7. Turn the inverter on.
8. Turn the device on.
9. To disconnect, reverse the above procedure.
NOTE: If more than one device is to be powered,
start one device at a time to avoid a power surge and
overloading the inverter. The surge load of each device
should not exceed the inverters Continuous Operation
wattage rate.
IMPORTANT: If you are using the power inverter to
operate a battery charger, monitor the temperature of
the battery charger for about 10 minutes. If the battery
charger becomes abnormally warm, disconnect it from
the inverter immediately.
All manuals and user guides at all-guides.com
• 10 •