Schumacher Electric PI-200 Manual Del Propietário página 9

1. Locate the positive and negative plastic terminals
located on the right side of the inverter and remove
the terminal caps completely.
2. Install the positive (red) cable ring lug onto the posi-
tive (red) terminal screw. Install the negative (black)
cable ring lug onto the negative (black) terminal
screw. Tighten each terminal so that the cable cannot
come loose.
CONNECTING INVERTER CAbLE TO A VEHICLE
(Models PI-200 and PI-400) (120 watts maximum):
1. Remove the cigarette lighter from its outlet.
2. Push the 12-volt power plug firmly into the outlet.
CONNECTING INVERTER CAbLES TO 12V bAT-
TERY OR 12V POWER SOURCE (Models PI-400 and
PI-750):
1. Keep hands, hair, clothing and jewelry clear of bat-
tery terminals.
2. Wear eye protection and clothing protection.
3. Connect the negative (black) inverter terminal cable
to the power source negative (-) or battery terminal.
Make sure the connection is secure.
4. Connect the positive (red) inverter terminal cable
to the power source positive (+) or battery terminal.
Make sure the connection is secure.
5.To disconnect the inverter, reverse the above steps.
NOTE: The internal speaker may make a brief "beep"
when the inverter is being connected to or disconnected
from the 12-volt power source.
All manuals and user guides at all-guides.com
• 9 •