If The Inverter Fuse Blows - Schumacher Electric PI-200 Manual Del Propietário

9.

If THE INVERTER fUSE bLOWS

Your power inverter is fitted with a fuse, which should
not have to be replaced under normal operating condi-
tions. A blown fuse is usually caused by reverse polarity
or a short circuit within the device or equipment being
operated.
If the fuse does blow:
1. Disconnect the device or equipment immediately.
2. Find the source of the problem, and repair it.
3. Install a new fuse, (25-amp for Models PI-200 and
PI-400 and 45-amp for Model PI-750). The fuse can
be found on the right side of the inverter.
Attention: Do not install a fuse higher than 25-amp for
Models PI-200 and PI-400 and 45-amp for Model PI-750,
as this may damage the inverter and any product you
use with the inverter. Make sure to correct the cause of
the blown fuse before using the inverter again.
All manuals and user guides at all-guides.com
• 14 •