Fein BLK1.3T Manual Del Usuario página 19

3 41 01 100 06 0.book Seite 19 Freitag, 5. Dezember 2008 11:55 11
Original instructions Nibbler.
Symbols, abbreviations and terms used.
Symbol, character Explanation
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this working step, pull the mains plug out of the socket. Otherwise there
will be danger of injury if the power tool should start unintentionally.
Use eye-protection during operation.
Use ear protection during operation.
Use protective gloves during operation.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Confirms the conformity of the power tool with the directives of the European Community.
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environment-friendly recycling.
Product with double or reinforced insulation
Ø Diameter of a round part
Max. work piece thickness for steel with up to 400 N/mm
Fe 400
Max. work-piece thickness for steel with up to 600 N/mm
Fe 600
Max. work-piece thickness for steel with up to 800 N/mm
Fe 800
Max. work piece thickness for aluminium with up 250 N/mm
Al 250
Pilot-drill for inside cut-outs
Ø
Min. inside curve radius
r
Weight according to EPTA-Procedure 01/2003
Character Unit of measure,
international
n /min
0
n m/min
S
P W
1
P W
2
M... mm
L dB
wA
L dB
pA
K...
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
/min, m/s
Unit of measure,
national
spm
m/min
W
W
mm
dB
dB
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2 2
rpm, m/s
2
2
2
2
Explanation
Stroke rate at no-load
Cutting speed
Power input
Output
Size of metric thread
Sound power level
Sound pressure level
Uncertainty
Acceleration
Basic and derived units of measure from the inter-
national system of units SI.
en
19