Setting The Alarm; Charging The Battery - Wiseup C7000 Guia Del Usuario

4. SETTING THE ALARM

To set the alarm on the clock, follow these steps:
4.1. While the current time is displayed, press the MODE Button once to enter
into the alarm setting mode, which will display "--:--".
4.2. Press the SET Button to adjust the alarm Hour, and use the UP and
DOWN Buttons to select the desired alarm hour.
4.3. Press the SET Button again to switch to the alarm Minute, and use the UP
and DOWN Buttons to select the desired alarm minute.
4.4. Press the SET Button again to switch to the snooze duration, and use the
UP and DOWN Buttons to set snooze duration.
4.5. Press the SET Button again to switch to the alarm sound; use the UP and
DOWN Buttons to switch between 6 different alarm tones that can be played
when the alarm goes off.
4.6. Press the SET Button to confirm the alarm sound, and then press the
MODE Button to exit the alarm setting mode.
[Note]: While the camera is in the alarm setting mode, to turn the alarm off, press the Up
Button until "--:--" appears on the LCD display screen, which indicates that the alarm is
disabled.

5. CHARGING THE BATTERY

Before using the camera, make sure that the camera is fully charged. Follow
these steps to recharge the battery:
5.1. Open the battery compartment on the back of the clock and remove the
plastic strip from the end of the battery.
5.2. Connect the camera to the adapter via the USB cable provided, and then
plug the adapter onto an outlet power socket to recharge the battery.
5.3. It will take up to 4 hours to obtain a full charge.