Section
Initial Settings
11
Adjusting initial settings
Initial settings lets you perform initial set up of
different settings for this unit.
1
display
FUNCTION
Shows the function status.
You cannot select AUDIO MENU from the OFF
SOURCE MENU.
1 Press
SOURCE
off.
2 Press
A.MENU
MENU is displayed.
3 Press 5 or ∞ to select
.
A.MENU
(FM tuning step)
FM STEP
(AM tuning step)
AM STEP
DETACH WARNING
(Auxiliary)
AUX
(Rear output and subwoofer)
REAR SP
(Telephone muting)
TEL/GUIDE
You can operate a desired function. For details,
refer to the pages for each of the functions.
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
on the remote control.
WIDE
50
En
All manuals and user guides at all-guides.com
1
and hold until the unit turns
and the OFF SOURCE
, and press
INIT
(Warning tone)
BAND/ESC
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Press 5 or ∞ to select
INIT MENU, and press
FM STEP adjustment indications are displayed.
2 Select the FM tuning step with 2/3.
Pressing 2/3 will switch the FM tuning step
between 50 kHz and 100 kHz. The selected FM
tuning step will appear in the display.
Note
• If seek tuning is performed in 50 kHz steps,
stations may be tuned in imprecisely. Tune in
the stations with manual tuning or use seek
tuning again.
Setting the AM tuning step
The AM tuning step can be switched between 9
kHz, the preset step, and 10 kHz. When using
the tuner in North, Central or South America,
reset the tuning step from 9 kHz (531 – 1,602
kHz allowable) to 10 kHz (530 – 1,640 kHz allow-
able).
1 Press 5 or ∞ to select
INIT MENU, and press
adjustment indications are displayed.
AM STEP
or
2 Select the AM tuning step with 2/3.
Pressing 2/3 will switch the AM tuning step
between 9 kHz and 10 kHz. The selected AM
tuning step will appear in the display.
from the
FM STEP
.
A.MENU
from the
AM STEP
.
A.MENU