Power On/Off; Turning The Unit On; Closing The Display; Screen Angle Adjustment - Pioneer AVH-P6450CD Manual De Operación

Power ON/OFF

02

Turning the unit on

1 Turn your vehicle's engine ON.
The display will be automatically deployed by
the automatic close/open mode.
If the display is not automatically deployed,
press
OPEN/CLOSE
2 Press
SOURCE
Press until you see
SOURCE

Closing the Display

Turn the vehicle's engine OFF.
The display will be automatically closed by the
automatic close/open mode. If the display does
not close automatically, turn the ignition switch
ON again (or turning it to ACC) and press
.
OPEN/CLOSE
Notes
• The automatic close/open mode will operate
the display as follows.
— When the ignition switch is turned OFF
while the display is deployed, the display
will be closed after approximately 6 sec-
onds.
All manuals and user guides at all-guides.com
.
to select the tuner
.
displayed.
Tuner
— When the ignition switch is turned ON
again (or turned to ACC), the display will be
deployed automatically.
— Installing the operation panel will automat-
ically deploy the display. (Refer to page 8.)
• The automatic close/open mode can be
switched ON/OFF. (Refer to page 55.)
• When the ignition switch is turned OFF after
the display has been closed, turning the igni-
tion switch ON again (or turning it to ACC)
will not deploy the display. In this case, press
to deploy the display.
OPEN/CLOSE

Screen Angle Adjustment

The angle of this product's screen continues
changing as long as you keep pressing the
button.
ANGLE
Adjust the screen to an easily viewable angle.
TEXT
Important
• If you can hear the display knocking against
your vehicle's console or dashboard, press
on the (–) side to move the screen a
ANGLE
little forward.
Notes
• When adjusting the angle, be sure to press
. Forcible adjusting of the display by
ANGLE
hand may damage it.
• The adjusted angle of the display will be mem-
orized and automatically returned to the next
time the display is deployed.
Section
02
En 13