Tabla de contenido
Publicidad
52
Troubleshooting 2
CD Player
Cannot play.
e Load a disc with label side up.
e If the disc is dirty, clean the surface of the disc.
e A blank disc has been loaded. Load a prerecorded
disc.
e Unfinalized CD-R/CD-RW disc is not playable.
Finalize the disc properly.
Sound skips.
e Place the unit on a stable place to avoid vibration
and shock.
e If the disc is dirty, clean the surface of the disc.
e Don't use scratched, damaged or warped discs.
No program playback.
e In the stop mode press PROGRAM button to
display "PROG.", and press play button to start
playing.
If normal operation cannot be recovered, unplug
the power cord from the outlet and plug it again.
Maintenance
If the surface of the unit gets dirty, wipe with a soft
cloth or use diluted neutral cleaning liquid. Be sure to
remove any fluid completely. Do not use thinner,
benzine or alcohol as they may damage the surface of
the unit.
Beware of condensation
When the unit (or a disc) is moved from a cold to a
warm place, or used after a sudden temperature
change, there is a danger of condensation; vapor in
the air could condense on the internal mechanism,
making correct operation impossible. To prevent this,
or if this occurs, leave the unit for one or two hours
with the power turned on. The unit will stabilize at the
temperature of its surroundings.
Memory Backup
The typical period for which the preset memory can be
backed up while the power cord is unplugged is about
one week subject to the surrounding environment. In
case of long hours of power failure or slipping out of
the power cord, the data may be cleared.
ENGLISH
Publicidad
Tabla de contenido
