Connecting The Boom Lights (Optional Accessory) - Nice M-BAR Serie Instrucciones Y Advertencias Para La Instalación Y El Uso

9.9 CONNECTING THE BOOM LIGHTS (OPTIONAL
ACCESSORY)
To perform the installation:
put the boom in the vertical position
1.
loosen the 6 screws that fasten the boom cover (A)
2.
57
remove the boom temporarily
3.
insert the cable grommet through the specially conigured
4.
hole (B)
58
B
feed the lights cable (C) through the rubber impact
5.
protector and, if necessary, use a ish tape to facilitate the
operation
59
C
C
90 – ENGLISH
6.
7.
a
A
60
8.
m
61
if necessary, shorten the lights cable by cutting it only in
one of the points indicated by an appropriate mark. After
cutting the cable, the cap of the cut end must be shifted
to close the new end
insert the wiring cable irst through the hole on the boom
support then through the hole in the cubicle
leave a bit of cable inside the boom support, so
that the boom can be rotated without causing any
tension along the cable.
connect the lights cable to the "LIGHT" terminal on the
control unit
the "LIGHT" output has poles: if the lights fail to
switch on according to the settings, the cables
connected to the terminal must be inverted.