Fein ASye 636 Kinetik Manual Del Usuario página 10

All manuals and user guides at all-guides.com
ASye/ASke 636 - Buch Seite 10 Mittwoch, 27. September 2000 9:04 09
EN
Operating the power tool.
Switching ON/OFF (2).
First check that the cable and plug are
not damaged.
Switching the power tool ON:
Press switch (2). Speed according to
how far the switch is pressed in.
Switching the power tool OFF:
To turn off, release switch.
Locking for continuous mode:
When the switch (a) is fully pressed in
(= maximum speed) press the locking
button (b).
To release, press switch (a) again and
then let go.
Drilling.
!
Risk of injury
by switching the tool ON unintentionally.
Before changing the tool, pull out the mains
plug.
Clamp the drill bit in the drill chuck (1).
Switch the power tool ON and OFF
using switch (a).
Changing the drill chuck (3).
!
Risk of injury
by switching the tool ON unintentionally.
Before changing the tool, pull out the mains
plug.
Insert the wedge drifts between the
drill chuck and drilling shaft connecting
collar.
Press the wedge drifts together - the
drill chuck disconnects from the drilling
shaft.
Before mounting the drill chuck,
remove any grease from the drilling
shaft.
Press the drill chuck firmly onto the
drilling shaft.
10
ASye 636 Kinetik / ASke 636 Kinetik
Cleaning and care.
!
Risk of injury
by switching the tool ON unintentionally.
Before cleaning, pull out the mains plug.
Carry out the following once a week, or
more often if the power tool is used more
frequently:
Clean the venting openings.
Blow out the motor space from outside
with dry compressed air.
Maintenance and repairs.
!
Risk of injury
Service, testing and repairs may only be car-
ried out by electrical engineers in conformity
with the regulations valid in the respective
country.
Maintenance and repairs.
We recommend our customer service
department (repair centre), FEIN author-
ized service centres and agencies.
Addresses can be found at the end of
these operating instructions and in the
enclosed safety instructions.
Please hand these operating instructions
to the repair centre. An overview of spare
parts can be found at the end of these
operating instructions.
Upon request a repair manual is sent to
the electrical engineers.
Only use original FEIN spare parts.
Maintenance work.
For stationary application using a drill
stand, remove the power tool from the
drill stand after every 50 hours of oper-
ation while it is warm, and for lubricat-
ing the motor and gears evenly, turn
the power tool through 180° and
switch it ON.