Broan best K210A Manual De Instalación página 11

15. USE AND CARE
Hood cleaning
Stainless steel cleaning: How to maintain its « BRIGHT LOOK »
Do:
- Regularly wash surfaces with clean cloth or rag soaked with warm water and mild soap or liquid
dish detergent.
- Always clean in the direction of original polish lines.
- Always rinse well with clear water (2 or 3 times) after cleaning. Wipe dry completely.
- You may also use a specialized household stainless steel cleaner.
Don't:
- Do not use any steel or stainless steel wool or any other scrapers to remove stubborn dirt.
- Do not use any harsh or abrasive cleansers.
- Do not allow dirt to accumulate.
- Do not let plaster dust or any other construction residues reach the hood. During construction or
renovation, cover the hood to make sure no dust sticks to stainless steel surface.
Avoid: when choosing a detergent
- Any cleaners that contain bleach will attack stainless steel.
- Any products containing : chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are
highly explosive and should never be used close to a range.
Enamel finish:
Clean with warm water and mild detergent only. When discoloration occurs, use a good enamel polish
such as automotive polish. (DO NOT use rough abrasive cleaner or porcelain cleaner.)
16. OPERATION
Always turn your hood on before you begin cooking to establish an air flow in the kitchen. Let the blower
run for a few minutes to clear the air after you turn off the range. This will help keep the whole kitchen cleaner
and brighter.
The hood is operated using the (3) slide controls located beneath the front edge of the hood.
HE0019
1) Light switch
2) blower speed control
3) Blower ON/OFF switch
COOKTOP LIGHTING (HALOGEN)
The light switch turns the halogen lights ON and OFF.
BLOWER
The blower is operated using two (2) controls.
Use the blower speed control to increase or decrease cooktop ventilation. Slide the control to the left to
increase the blower speed - to the right to decrease the blower speed.
The blower ON/OFF switch turns the blower ON to the speed pre-set by the speed control. The blower must
be turned On and OFF using this switch.
(CONT'D)
1 2
- 11 -
3