Chevrolet Cavalier 1995-1999; Chevrolet Corvette 1997-2004; Pontiac Firebird 1993-2002 - Metra T 4544-444 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Chevrolet Cavalier 1995-1999

1. Open drivers door and remove fuse panel on end of dash.
2. Open passenger door and remove panel on end of dash.
3. Remove (1) Phillips screw from each side, now exposed.
4. Remove (3) 7mm hex-head screws from the top of the
glove box liner.
5. Remove (2) 7mm hex-head screws from the top-left corner
of the glove box cavity.
6. Remove (1) Phillips screw from the defroster duct.
7. Remove the duct work and (1) Phillips screw exposed.
8. Remove the dash pad and (3) Phillips screws exposed at
the top of the radio trim bezel.
9. Locate Bracket Set #10 (no cutting is required). (Figure B)
Continue to "Continued Installation Instructions for
ALL VEHICLES".
(Figure A)
(Figure B)
®
Dash Disassembly 4544-444

Chevrolet Corvette 1997-2004

1. Pry out on the ride control switch and disconnect wiring.
2. Unsnap the switch trim and remove (2) 10mm hex-head
bolts exposed. (Figure A)
3. Open the center console door, remove (4) screws from the
inner hinge and remove the door.
4. Open the ashtray and remove (1) screw exposed.
5. Remove the ashtray and (1) screw exposed.
6. Unclip the small grille to the left of the ignition switch and
remove (1) screw exposed.
7. Unclip the base of the radio trim bezel and remove.
8. Locate Bracket Set #10 (no cutting is required). (Figure B)
Continue to "Continued Installation Instructions for
ALL VEHICLES".
(Figure A)
32
(Figure B)
Pontiac Firebird
1993-2002
1. Unclip the radio trim bezel.
(Figure A)
2. Remove (4) 7mm hex-head screws
securing the factory radio and
disconnect the wiring.
3. Locate Bracket Set #9 (no cutting
is required). (Figure B)
Continue to "Installation
Instructions, ALL VEHICLES".
(Figure A)
(Figure B)

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido