Metra T 4544-444 Instrucciones De Instalación página 36

For top and/or bottom mounting brackets:
1. Attach the top and/or bottom bracket to the
radio housing using carriage bolts and Keps nuts
provided with the kit.
2. Slide the extension housing into the radio
housing until it reaches the desired depth.
Note: Ensure the holes on the side of the kit are
clear. If not, remove the extension housing, flip it
upside down, and then slide the extension housing
back into the radio housing.
Flush mounting depth shown above
(Figure A)
4544-444
Installation Instructions, All Vehicles
3. Attach carriage bolts and Keps nuts into the
holes on the sides of the assembled housing.
Note: The carriage bolts must be inserted from the
inside of the housing.
For side mounting brackets:
1. Slide the extension housing into the radio
housing until it reaches the desired depth.
Note: Ensure the holes on the side of the kit are
clear. If not, remove the extension housing, flip it
(Figure B)
®
36
upside down, and then slide the extension housing
back into the radio housing.
2. Attach the brackets to the assembled housing
through the holes on the sides of the kit.
Note: If using bracket sets #9 or #10, you must
insert the carriage bolts from the outside of the
housing.
Continued on next page
(Figure C)