Chevrolet Astro/Gmc Safari 1990-1995; Chevrolet Blazer (Full Size)/Suburban 1989-1991; Gmc Jimmy (Full Size)/Suburban 1988-1991 - Metra T 4544-444 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Chevrolet Astro/GMC Safari 1990-1995

1. Remove the (2) Phillips screws from the bottom of the console trim ring
around the factory radio. (Figure A)
2. Carefully pull up on the edge of the console trim ring, unclip and remove it,
then set aside.
3. Remove the (4) Phillips screws holding the factory radio, remove the radio unit
itself and disconnect wiring from the rear of the unit.
4. Locate the Metra Bracket Set #1. Then, using wire cutters cut and remove
all mounting tabs on the Bracket Set EXCEPT the tabs marked on the back
with a letter "A". (Figure B)
Continue to "Installation Instructions, ALL VEHICLES".
(Figure A)
Dash Disassembly 4544-444
"A"
(Figure B)
®
Chevrolet Blazer
Jimmy
(full size)
1. Remove the (2) Phillips screws from the plastic trim ring around the factory
radio, remove the trim ring itself and set aside. (Figure A)
2. Remove the (2) Phillips screws holding the factory radio, remove the radio unit
itself and disconnect wiring from the rear of the unit.
3. Remove the original brackets that mount the factory radio to dash.
(Figure B)
Note: Keep the old brackets for mounting the new radio.
Continue to "Installation Instructions, ALL VEHICLES".
(Figure A)
12
Suburban/GMC
(full size)/
/Suburban 1988-1991
(S10 application
shown as example)
(Figure B)

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido