Etac molift Mover 300 Manual De Usuario página 10

Molift Smart 150 / www.etac.com
Safety devices
Molift Mover 300 is equipped with several safety
devices, which are intended to prevent damage or
injuries to personnel and equipment in the case of
incorrect use.
The lifter has an overload sensor preventing the
lifter to be operated if the load exceeds SWL.
The lifting arm is hinged to prevent the arm
and sling bar from squeezing the user. The
actuator will not produce any force when moving
downwards.
The electronics are disabled if overheated. Wait
until the lifter has cooled down before using it
again.
Push handles
Use the push handles to move the lifter.
Do not push or pull the user,
lifting arm or actuator.
This may cause stability prob-
lems and lifter may tip over.
The lifter shall only be used for movement
over short distances. It is not a replacement
for wheelchair or similar.
Brakes
Rear wheels/castors are equipped with brakes.
Step on lever to lock brakes. Flip up to unlock.
All manuals and user guides at all-guides.com
Emergency stop / Emergency lowering
Emergency stop
The emergency stop shuts off the power when
pushed in. Turn clockwise to reset (OK to operate
when the green ring is visible).
Electrical emergency lowering
Push and hold button for electrical emergency
lowering to lower lifting arm. The electrical emer-
gency lowering function does not work when the
emergency stop is activated.
Manual emergency lowering
Turn the top of the actuator clockwise and the
lifting arm moves downwards if under load.
The manual emergency lowering function on the
actuator should only be used when the electrical
emergency lowering does not work.
10
Electrical
emergency
lowering
Manual
emergency
lowering
Emergency
stop