Tabla de contenido
Publicidad
Safety
Signs, symbols and instructions placed on this product must never be covered or removed and must remain
present and clearly legible throughout the entire lifetime of the product. Immediately replace or repair illegible
or damaged signs, symbols and instructions. Contact your local dealer for instructions.
In case of an adverse event occurred in relation to the device, incidents should be reported to your local
dealer and the national competent authority in a timely manner. The local dealer will forward information to
manufacturer.
EN
Caregiver
•
Read the "User Guide" carefully before use and
keep it for future reference. Incorrect use of this
product may cause serious injury to the user.
•
Carry out all positional adjustments on the product
and accessories and ensure that all knobs, screws
and buckles are securely fastened before use.
Keep all tools out of the reach of children.
•
Always use the correct lifting techniques and aids
for this purpose.
•
Ensure the stability of the product is maintained
before placing the user in it.
•
This product contains small parts which could
present a choking hazard if removed from their
intended placing.
•
Never leave the user unattended in this product.
Ensure permanent supervision by a caregiver.
•
Repair/replacements must only be made using
new original R82 spare parts and fittings and
carried out in accordance with the guidelines and
service intervals prescribed by the supplier.
•
If there is any doubt as to the continued safe use
of your R82 product or if any parts should fail, stop
using the product immediately and contact your
local dealer as soon as possible.
•
Ensure that moving parts does not squeeze or trap
body parts when adjusting them.
•
Ensure that body parts are not trapped in openings
for mounting of supports/accessories.
•
Be careful not to get body parts trapped, when
placing the product over the toilet.
•
Activate the brakes before placing the user into
the product.
•
The user must not occupy the product when it is
lifted from the ground.
•
All gasspring are to be kept lock, when the device
is not being adjusted.
•
Be aware of any MAX mark indications before
adjustment.
Environment
•
Observe the surface temperature on the product,
before placing an user in it. This goes especially for
users with insensitive skin as they cannot feel the
heat or cold. If the surface temperature is above
41°C then allow the product to cool before use.
•
For the purpose of safety and comfort, always
check the water temperature before bathing the
user.
User
•
If the user is close to the max. load limit and/or
has a lot of involuntary movements, e.g. rocking,
a larger size with a higher max. load or a different
R82 product should be considered.
•
When changing user, clean the product and
disinfect it if necessary. Carry out necessary
adjustments after cleaning.
Product
•
Carry out all positional adjustments on the product
and accessories and ensure that all knobs, screws
and buckles are securely fastened before use.
Keep all tools out of the reach of children.
•
Ensure the stability of the product is maintained
before placing the user in it.
•
Unoccupied device is suitable for land and air
transport.
•
The device is only designed to travel short
distances within the same room.
•
Resistance to ignition is not claimed for this
product.
•
The product might change its resistance to ignition
characteristics if using other than original R82:
Cushions.
22
www.etac.com
Publicidad
Tabla de contenido
