Installing The Grille - Mitsubishi Electric Mr.SLIM SLZ-KA09NA Manual De Instalación

7. Installing the grille

Fig. 7-1
Min.22-11/16
Min.24-13/32
Fig. 7-2
Fig. 7-3
Fig. 7-4
Fig. 7-5
10
7.1. Check the grille accessories (Fig. 7-1)
• The grille should be supplied with the following accessories.
Accessory name
Grille
Screw with washer
Gauge
Fastener
Band
7.2. Preparing to attach the grille (Fig. 7-2)
• With the gauge supplied with this kit, adjust and check the positioning of the unit
(inch)
relative to the ceiling. If the unit is not properly positioned in the ceiling, there
may be air leaks, condensation may form, or the up/down vanes may not operate
correctly.
• Make sure that the opening in the ceiling is within the following tolerances:
576 × 576 - 620 × 620 mm, 22-11/16 × 22-11/16 inch to 24-13/32 × 24-13/32 inch.
• Make sure that step A is performed within 27-32 mm, 1-1/16 to 1-1/4 inch. Dam-
age could result by failing to adhere to this range.
Main unit
Ceiling
Gauge (Accessory)
Ceiling opening dimensions
7.2.1. Removing the intake grille (Fig. 7-3)
• Slide the levers in the direction indicated by the arrow
• Unlatch the hook that secures the grille.
* Do not unlatch the hook for the intake grille.
• With the intake grille in the "open" position, remove the hinge of the intake grille
from the grille as indicated by the arrow
7.2.2. Removing the corner panel (Fig. 7-4)
• Remove the screw from the corner of the corner panel. Slide the corner panel as
indicated by the arrow
Intake grille
Grille
Intake grille levers
Grille hook
7.3. Installing the grille
• Please pay attention because there is a restriction in the attachment position of
(inch)
the grille.
7.3.1. Preparations (Fig. 7-5)
• Install the 2 enclosed screws with washer in the main unit (at the corner refriger-
ant pipe area and at the opposite corner) as shown in the diagram.
Main unit
Detailed diagram of installed screw with washer (accessory).
Q'ty Remark (mm, inch)
1 650 × 650 , 25-19/32 × 25-19/32
4 M5 × 0.8 × 25, M5 × 1/32 × 31/32
1
2
2
to open the intake grille.
.
to remove the corner panel.
Hole for the grille's hook
Corner panel
Screw