USING YOUR STEAM AND SCRUB MOP
1
1
Make sure that your pads are secured to
the nozzle discs.
Twist the quick-release cord holder
to unwrap the power cord completely.
Plug into an electrical socket.
2.
2 To start cleaning, put your foot on the
floor head and pull the handle towards
you. This will engage the power pads
Please note, if the handle is not reclined
with in 30 seconds of selecting a mode
the mop goes back into standby.
NOTE: If the handle is not reclined the pads do not spin.
NOTE: To prolong the life of your steam mop, we recommend using distilled water.
NOTE: Sweep or vacuum your floors prior to cleaning with your steam mop.
NOTE: Both pads must be installed at all times during use.
35
sh a rkclea n.eu
3.
3 When the mop is first plugged in,
the unit will be in Standby Mode
and 2 Indicator Lights will blink.
Using the mode button select your
preferred setting.
4 Mop with a forward and backward motion.
5 When the water tank is empty, the steam
mop will stop producing steam. Make sure
the unit is unplugged before refilling the
water tank.
6 When finished mopping, press the mode
button. The blue light will blink, indicating
that the unit is in Standby mode. Once in
Standby mode, lift the handle to bring the
steam mop back to the upright position
and unplug the unit.
7 Please wait 2 to 3 minutes for the steam
mop to cool completely before removing
the Dirt Grip pads.
Never leave the steam mop with damp
or wet Dirt Grip pads on any floor for an
extended period.
TIP: When cleaning near skirting boards,
edges, or furniture, you may feel a slight pull
from the unit making contact with surfaces.
This is normal and not a cause for concern.
INTELLIGENT STEAM CONTROL
The Shark® Steam and Scrub Mop has 2 unique Intelligent Steam Control settings so you can
select the ideal amount of steam to use for each cleaning task. In DEEP MODE, the pads will
spin faster and more steam will be produced. See below for tips on when to use each setting.
SETTING
IDEAL FOR THESE
SEALED SURFACES
LIGHT
Laminate
Hardwood
Vinyl
NORMAL
Marble
Tile
Stone
TO SANITISE:
1
Attach clean Dirt Grip pads to the scrubbing nozzle.
2 Plug in the unit, tilt the mop handle down towards you, and press the mode button to select
the DEEP setting. The pads will then start spinning.
3 Wait 30 seconds for the unit to begin producing steam.
4 Start mopping with a forward and backward motion on an appropriate sealed hard floor
surface. After three minutes, your unit will be ready to sanitise.
5 Using a forward and backward motion, move the unit slowly and evenly over the area to be
sanitised while applying continuous downward pressure. Slowly repeat at least 8 times.
RECOMMENDED USAGE
Cleaning delicate surfaces
Light cleaning and dusting
Loosening and lifting light dirt
Basic, everyday cleaning
Cleaning large areas
Cleaning moderate and heavy traffic areas
s ha rkc l ea n.eu
36