Hob Cleaning And Maintenance; Support; Positioning - Franke FHM 604 4E Instrucciones Para El Uso E Instalacion

Hob cleaning and maintenance

Before carrying out any hob cleaning or maintenance, always unplug the appliance or
disconnect the power by means of the main switch.
• Stainless steel and enamelled parts will remain pristine if regularly cleaned with water
or using specific products, and thoroughly drying them afterwards.
• To restore the original lustre, periodically use Franke's special stainless-steel cleaner
and microfibre cloth, available from your retailer or the Franke After-sales Service.
• NEVER use steam equipment, scouring pads or steel wool, muriatic acid or other
products which could scratch or mark the surface.
• Do not leave acid or alkaline substances or rusty iron items on the hob.
• Clean the hotplates with a damp cloth and rub with a little oil when still warm.

Support

In case of possible operating problems, contact a Franke Service Centre (see attached
list).
Never make use of unauthorised technicians.
Specify:
– Type of fault;
– Appliance model (Art.);
– Serial number (S.N.);
This information is given on the appliance dataplate on the warranty certificate.

Positioning

Operations for appliance installation are given below. These procedures must be carried
out exclusively by a qualified technician, in accordance with local regulations, as installation
by an unqualified person may constitute a health hazard
The manufacturer declines any liability for injury or damage resulting from
failure to comply with these provisions.
Preparing the cabinet
This handbook refers to a class 3 built-in hob.
Prepare the cut-out in the worktop as per the measurements shown in fig. 1
12
All manuals and user guides at all-guides.com