General Information; Information For The Reader; Identification Of Manufacturer And Appliance; Purpose Of The Manual - Angelo Po FC 611 G Manual De Uso E Instalación

INFORMATION FOR THE READER

To find the specific topics of interest to you quickly, refer to the
index at the start of the manual.
This manual is subdivided into two parts.
st
1 part: contains all information necessary for general
readers, i.e. for users of the appliance.
nd
2 part: contains all the information necessary for spe-
cial categories of reader, i.e. all skilled operators author-
ised to handle, transport, install, service, repair and scrap
the appliance.
While users are instructed to refer to the 1
part is addressed to skilled operators. They may also read the
st
1 part for a more complete picture of the information provided
if necessary.

PURPOSE OF THE MANUAL

The constructor has produced this manual, which forms an in-
tegral part of the appliance, to provide the necessary informa-
tion for those authorised to interact with it during its working life.
As well as adopting good practices for use, the manual's intend-
ed readers must read it thoroughly and apply its instructions to
the letter. The constructor supplies this information in its own
language (Italian), but it may be translated into other languages
to meet legal and/or commercial requirements. A little time tak-
en to read this information will allow the prevention of risks to
health and safety, and the risk of economic losses.
Keep this manual in a clearly identified safe place throughout
the working life of the appliance, so that it will always be
available when required for consultation.
The constructor reserves the right to make changes without
any obligation to provide any prior notice.
A number of symbols have been used to highlight particularly
important parts of the text or important specifications.
IT
GB
DE
FR
T
N
R
ES
S
S
English

GENERAL INFORMATION

st
part only, the 2
A B C
R Q P N R Q
Their meaning is as defined below.
Caution - warning
Indicates that suitable procedures must be adopted to
avoid putting people's health and safety at risk or caus-
ing economic losses.
Important
Indicates particularly important technical information
which must not be overlooked.
nd
IDENTIFICATION OF
MANUFACTURER AND APPLIANCE
The nameplates shown here are fitted directly to the appliance.
One (fig.1) contains references and all essential information for
operating safety, and the other (fig. 2) the information about the
gases for each country of use.
1/1
A)Appliance model.
B)Type of customisation.
C)Manufacturer identification.
D)Type of fume exhaust vent.
E)Serial number.
F)Protection rating.
G)CE conformity mark.
H)Reference standard.
L)CE certificate number.
M)Product family type.
N)Gas pressure.
P)Gas consumption.
Q)Rated power.
R)Type of gas.
S)Testing gas indicator.
T)Code of country of destination.
PROCEDURE FOR REQUESTING
SERVICE
Contact one of the authorised service centres for all require-
ments.
When requesting service, state the data provide on the name-
plate and provide a description of the fault.
D E F
P N
- 2 -
fig. 2
G H
fig. 1
M L
1
1/2
1/3
IDM-3960320020.tif