Tsc Function; Display Mode; Boiler Probe Calibration - Rancilio classe 10 SDE Manual Para El Técnico

- Test Volumetric Counters
This checks that the volumetric counters of each
group work correctly when water passes.
Press "enter" to display the different volumetric coun-
ters of the groups. Press the START/STOP button
(E) of each group to display the count increase of
each counter.
If the automatic operation mode is set for one or
both cases (coffee groups and TSC), at the fixed
time, a message on the display will remind to start
the washing cycles.
4.2.12 TSC functions
The temperature values and milk cream level are set.
The following options are visualized:
For "whipped milk" the final milk temperature can be
set (in °C / °F degrees) as well as the whipping level
ranging from 1 to 12.
Also for "non whipped milk" , in addition to the final
temperature, a slight whipping can be set (ranging
from 1 to 12).
4.2.13

Display mode

Select what to show on the display: the time and date
or the pressure value of the boiler and the date.
48
All manuals and user guides at all-guides.com
4.2.14 Cleaning
This submenu gives the possibility of setting all
modes concerning the washing of coffee groups,
TSC and washing counters.
If the automatic operation mode is set for one or
both cases (coffee groups and TSC), at the fixed
time, a message on the display will remind to start
the washing cycles.

4.2.15 Boiler probe calibration

This programme is used to align the boiler pressure
sensor with the reference value using software.
The display shows the pressure measured by the
sensor in real time and the corresponding value,
which must be aligned.
Check that the read pressure with a reference mano-
meter equals the one read by the sensor.
If the manometer shows a higher or lower pressure
value, make the changes using the "+" or "-" buttons
in order to align the pressure control system. Then,
press "enter" to confirm.