The Cup-Warmer Button; The Hot Water Buttons; Steam Tsc (Optional); Emulsion Steam Tsc (Optional) - Rancilio classe 10 SDE Manual Para El Técnico

3.2.1

The Cup-Warmer Button

When the button (F) is pressed, the display shows the
set power status of the resistance, which can be of four
types (off – minimum – medium – maximum).
If the button is pressed again within 2 seconds, the
set power status of the resistance moves to the next
step.
When the cup-warmer resistance is active (min, med,
or max status), the relative LED lights up.
OFF
MINIMUM
3.2.2

The Hot Water Buttons

When the G button is pressed, water is dispensed
with the economizer with controllable temperature for
the set time or up to when the button is pressed again.
During dispensing, the pump is switched on.
When the H button is pressed, water is obtained
directly from the boiler for the set time or until the
button is pressed again.
If the two buttons are pressed for 2 seconds, dispen-
sing is continuous and only stops when the buttons
are pressed again.
Dispensing is discontinued automatically after 60 se-
conds (for button G) and 30 seconds (for button H).
If the dispensing time is set to 0 seconds, the button
carries out start/stop functions. If the time is set from
0.1 to 2 seconds, dispensing occurs for 2 seconds.
3.2.3

Steam TSC (Optional)

When the I button is pressed, the steam dispensing
solenoid valve is excited until the set temperature is
reached or until the button is pressed again.

3.2.4 Emulsion steam TSC (Optional)

Press the button L to excite the steam and emulsion
delivery electromagnetic valves until the programmed
temperature and froth level are reached or until the
function is switched off.
Vapore TS
In this case, you can configure the two buttons (I - L)
with different temperatures
es:
button I
button L
3.3

Programming Panel

This panel features 4 buttons with the following
functions:
All manuals and user guides at all-guides.com
MEDIUM MAXIMUM
55°C
65°C
Button with "+" sign
To move to a higher level in the programming
menus Or to increase the value
Button with "-" sign
To move to a lower level in the programming menus
Or to decrease the value
Button with "enter" sign
To enter the programming menu Or to confirm
entries
Button with "esc" sign
To quit the menu Or to quit programming mode

3.4. Washing

3.4.1 Washing of the coffee groups

At the fixed time, if the automatic washing (par.2.6)
mode is enabled, a message on the display requests
to wash the coffee groups.
Keep "ENTER" button pressed to start washing until
the display shows:
Coffee Cleaning Cycle
Start cleaning cycle
Group?
press <ENTER>
If you press "enter" within 10 seconds, the following
cycle starts (if you do not leave this menu automa-
tically):
- The display shows:
Coffee Cleaning Cycle
Insert the blind
filters then
press <ENTER>
- When you press "enter", the cleaning cycle starts
and the display shows:
Coffee Cleaning Cycle
CLEANING RUNNING
The machine carries out n. 10 cycles as follows:
- Starts dispensing from the groups for 10 sec.
- Pauses for 10 sec.
At the end of the 10 cycles, the display reads:
Coffee Cleaning Cycle
Remove the
filterholders
press <ENTER>
If you press "enter" the display shows:
RINSE RUNNING
The machine carries out n. 2 cycles as follows:
- Starts dispensing from the groups for 30 sec.
- Pauses for 30 sec.
41