Publicidad
Step 10
Fasten the UPRIGHT (I) to the DESK TOP (E) and BOTTOM (M). Tighten four TWIST-LOCK® FASTENERS.
å
Fasten the MAGNETIC CATCH (MM) to the UPRIGHT (I). Use a BLACK 1-1/8" PAN HEAD SCREW (AAA).
å
Fasten four ANGLE BRACKETS (QQ) to the LEFT END (B), UPRIGHT (I), and BOTTOM (M). Use four BLACK 9/16" LARGE
å
HEAD SCREWS (FFF).
NOTE: Be sure the edges of the ANGLE BRACKETS are even with the edges of the LEFT END, UPRIGHT, and BOTTOM.
å
Fasten the BASE (AA) to the LEFT END (B), UPRIGHT (I), and BOTTOM (M). Use four BLACK 9/16" LARGE HEAD
å
SCREWS (FFF) through the ANGLE BRACKETS and into the BASE.
Fasten three ANGLE BRACKETS (QQ) to the DESK TOP (E). Use three BLACK 9/16" LARGE HEAD SCREWS (FFF).
å
Fasten the DESK TOP MOLDING (W) to the DESK TOP (E). Use three BLACK 9/16" LARGE HEAD SCREWS (FFF) through
å
the ANGLE BRACKETS and into the MOLDING.
NOTE: There are no pre-drilled holes in the DESK TOP MOLDING (W). The SCREWS will tighten into the groove.
å
NOTE: Be sure the DESK TOP MOLDING (W) is touching
å
the END MOLDING (X).
Unfi nished edge
B
QQ
(7 used)
www.sauder.com/services
Be sure these edges
are touching each other.
MM
X
AA
I
M
QQ
QQ
W
E
BLACK 9/16" LARGE HEAD SCREW
(14 used for the ANGLE BRACKETS)
101736
AAA
BLACK 1-1/8" PAN HEAD SCREW
(1 used for the MAGNETIC CATCH)
FFF
Groove
Page 15
Publicidad
