Publicidad
Step 12
Insert the LONG METAL PIN (PP) into the hole in the top edge of
å
the RIGHT END (A). Only insert about 1/4 of the PIN into the hole.
Fasten the RIGHT END (A) to the DESK TOP (E) and MODESTY
å
PANEL (L). Tighten four TWIST-LOCK® FASTENERS.
NOTE: Be sure the LONG METAL PIN in the RIGHT END inserts
å
into the hole in the DESK TOP.
Fasten an ANGLE BRACKET (QQ) to the RIGHT END (A) and
å
LONG END MOLDING (Y). Use two BLACK 9/16" LARGE
HEAD SCREWS (FFF).
NOTE: There is no pre-drilled hole in the LONG END
å
MOLDING (Y). The SCREW will tighten into the
groove. Do not overtighten the SCREW.
QQ
BLACK 9/16" LARGE HEAD SCREW
(2 used for the ANGLE BRACKET)
www.sauder.com/services
A
Y
PP
FFF
E
L
101736
Page 17
Publicidad
