Publicidad
Step 4
Slide the SHORT END MOLDINGS* (Z) onto the notched
å
edges of the HUTCH ENDS (C and D) until they touch the
HUTCH TOP MOLDING (V).
Insert eight METAL PINS (OO) into the ends of the PINNED
å
UPRIGHTS (K). Only insert about 1/4 of each PIN into
the holes.
Now, insert four of the METAL PINS in the ends of the
å
PINNED UPRIGHTS (K) into the holes in the HUTCH TOP (F).
* U.S. Pat. No. 5,499,886
å
Slide the SHORT END
MOLDING (Z) onto
the notched edge.
These surfaces
should be even.
www.sauder.com/services
Finished edge
Z
K
K
D
OO
OO
(8 used)
V
F
Z
Slide the SHORT END
MOLDING (Z) onto
the notched edge.
101736
Notched edge
C
These surfaces
should be even.
Page 9
Publicidad
