Adjusting The Blade Closing; Special Maintenance; Maintanance Table; Disposal Of Exhaust Materials - CAMPAGNOLA HOLLY Manual De Uso Y Mantenimiento

WARNING!
Cleaning the harvesting head allows to limit frictions, which would jeopardize tool performance and work
autonomy.

Adjusting the blade closing

Before storing the tool for a prolonged period, carry out the following operations:
• Take the harvesting head to a Campagnola Authorised Service Point for being cleaned and greased.
• Store it in its box in a dry place.

Special maintenance

WARNING!
Any special maintenance operation shall be carried out only by a Campagnola Authorised Service Point.
AUTHORIZED SERVICE POINT
It is the Service Point authorized by the Manufacturer for repairing the products.

Maintanance table

Maintenance
Check the screws for proper tightening
Clean the harvesting head and lubricate the
anti-rotation drives with Campagnola
LISYNT-00-EP spray grease
Thorough overhoul by a Campagnola Au-
thorised Service Point

Disposal of exhaust materials

After having been installed and during use, the machine does not cause any environmental pollution. However,
throughout its working life, some types of residual waste or exhaust materials, such as the lubricants for the
mechanical components, are being produced in certain maintenance situations.
There are specific regulations in every Country as for the disposal of these materials and the environment
protection. The Customer is required to be knowledgeable in the Laws in force in his own Country and to oper-
ate only while complying with these regulations, according to the indications in the product technical charts,
which may be obtained from the Manufacturer.
WARNING!
The Laws in force about the disposal of mineral oils or greases used for the lubrication / maintenance opera-
tions must be followed.
WARNING!
More information about the disposal of oils and other substances can be found in the safety chart of the sub-
stances.
The steps employed in the disposal of toxic waste including the collecting, transporting, processing (transfor-
mation for recycling), as well as the deposit and the dumping onto the ground are all usual activities of common
interest and are subject to the following general principles:
a) Any risks of injuries or dangers for the health and safety of any individual and of the community
have to be avoided.
b) Compliance with any and all hygienic-sanitary requirement and avoidance of any air, water,
ground and underground pollution have to be guaranteed.
Compliance with efficient and economical principles in order to save and recycle energy and materials shall be
promoted.
Use and maintenance manual – Translation of
original Instruction Rev.: 03, Date 10/09/2021
After the first After 200 work
8 work hours hours
X
X
At the end of every work season
and/or every 400 work hours
X
Page 21