Publicidad
Step 8
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as
å
shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (35MA) to the ENDS (A and B). Use four GOLD 5/16"
å
FLAT HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
å
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the END. Turn a SCREW into this hole.
NOTE: The EXTENSION SLIDES (35MC) will be used later for the DRAWER.
å
Push the black lever in and pull the SLIDE from the RAIL.
Edge with
CAM DOWELS
1
Open end
This hole is closer
to this edge.
Page 12
35MC
GOLD 5/16" FLAT HEAD SCREW
B
3
2
3S
(4 used in this step)
A
35MA
1
2
3
Open end
Publicidad
