Sauder 423809 Manual Del Usuario página 8

Step 4
Carefully fl ip the ENDS (A and B) over.
å
Turn six BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the ENDS (A and B) until the shoulders of the SCREWS
rest on the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (E) onto the ENDS (A and B).
å
Line up the grooves in the MOLDINGS over the heads of
the SCREWS in the ENDS.
NOTE: The MOLDINGS should be centered on the ENDS.
å
NOTE: If the MOLDING comes up off of the SCREWS,
å
remove it and slide it on again.
Page 8
A
E
B
E
BLACK 9/16" FLAT HEAD SCREW
(6 used in this step)
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
32S
Shoulder