Using The Machine - Stiga Villa Instrucciones De Uso

Ocultar thumbs Ver también para Villa:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 74
All manuals and user guides at all-guides.com
GB
Depress the freewheel clutch pedal fully.
Move the parking brake to the right and
then release the pedal.
The parking brake is released by pressing the free-
wheel clutch pedal lightly. The spring-loaded
brake lever then moves automatically to the side.
5. POWER TAKE - OFF (IN)
A lever for engaging the power take-off for driving
front-mounted accessories. There are two posi-
tions:
1. Lever in lower position - power take-off
disengaged.
2. Lever in upper position - power take-off
engaged. The lever is locked in this posi-
tion if a person weighing more than 30 kg
is sitting on the seat.
6. POWER TAKE - OFF (OUT)
A spring-loaded lever for disengaging the power
take-off.
Press the button to disengage the power
take-off.
7. SEAT SUSPENSION
Rotary control for variable adjustment of the seat
suspension. Adjust to weight of driver.
1. Turning counter-clockwise -
suspension will become softer.
2. Turning clockwise - suspen-
sion will become harder.
If the suspension is tightened too hard it could
mean that the lever for engaging the power take-
off (5) cannot be locked in its upper position.
NOTE! To prevent a deterioration in mobility,
do not over tighten the screw joints in the seat
suspension.
8. GEAR LEVER
A lever for selecting one of the five forward gears
in the gearbox (1-2-3-4-5), neutral (N), or reverse
(R).
When changing from neutral to forward or re-verse
the gear lever must be lifted upwards.
The pedal must be kept depressed when changing
gear.
NOTE! You must make sure the machine is quite
40
ENGLISH
stationary before changing from reverse to forward
gear or vice versa. If a gear does not engage imme-
diately, release the pedal and depress it again, and
then engage the gear once again. Never force a
gear in.
11. THROTTLE/CHOKE CONTROL
A control for setting the engine speed and to choke
the engine when starting from cold.
1. Idle.
2. Full throttle - when the machine is in
operation, full throttle should always be
used. Full throttle positioned 1 - 1.5 cm
from the lower edge of the groove.
3. Choke - for starting a cold engine.
Choke positioned at the bottom of the
groove.
12. STARTER KEY
An ignition key used for starting and stopping the
engine. There are three positions:
1. Stop position - engine short circuited.
STOP
The key can be be removed.
2. Drive position (without symbol).
3. Start position - the electric starter motor
START
is activated when the key is tur-ned to the
spring-loaded start position. Once the en-
gine has started, allow the key to return to
the drive position.

USING THE MACHINE

AREAS OF USE - VILLA
The machine may only be used for the following
tasks using the STIGA accessories stated:
1. Mowing
Using mower deck 13-2916 (85M) or 13-2910
(102M).
2. Sweeping
Using brush unit 13-0920. Use of dust guard
13-1937 is recommended.
3. Snow clearance
Using snow blade 13-1917. Snow chains
13-1947 and wheel weights 13-1982 are

Publicidad

Tabla de contenido
loading

Tabla de contenido