Stihl MS 201 T Manual De Instrucciones página 26

English
While pushing down on the cap, turn
N
it clockwise about 1/4 turn until it
comes to a stop.
The marks on the tank cap and fuel tank
must line up.
Fold the grip down so that it is flush
N
with the top of the cap.
24
Tank cap should be properly tightened.
If the tank cap cannot be locked in the
fuel tank opening
Check cap for tightness. If it can be
moved, the bottom of cap may be
twisted out of the correct position for
installation in relation to top.
Remove the cap from the fuel tank
N
and check it from above.
1
Left: Bottom of cap is twisted out
of the correct position for
installation – inner mark (1)
in line with outer mark.
Right: Bottom of cap in correct posi-
tion for installation – inner
mark is under the grip. It is
not in line with the outer mark
on the cap.
Place the cap in the fuel tank
N
opening and rotate it
counterclockwise until it drops fully
into the opening.
Continue rotating the cap
N
counterclockwise (about 1/4 turn
until it stops) – this causes the
bottom of the cap to be turned to the
correct position for installation.
Turn the cap clockwise for closing –
N
see section on "Closing."
MS 201 T