Stihl MS 201 T Manual De Instrucciones página 50

English
Specifications
EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Engine
Single cylinder two-stroke engine
48
Displacement: 2.15 cu. in.
(35.2 cm
Bore: 1.60 in (40 mm)
Stroke: 1.10 in (28 mm)
Engine power to 2.4 hp (1.8 kW)
ISO 7293: at 9,500 rpm
Idle speed: 3,000 rpm
Maximum permissi-
ble speed with bar
and chain: 14,000 rpm
Ignition system
Electronic magneto ignition
Spark plug
(suppressed): NGK CMR 6 H
Electrode gap: 0.02 in (0.5 mm)
Fuel system
All position diaphragm carburetor with
integral fuel pump
Fuel tank capacity: 10.5 fl.oz (0.31 l)
Chain lubrication
Fully automatic, speed-controlled oil
pump, additional manual oil flow control
Oil tank capacity: 7.4 fl.oz (0.22 l)
Weight
dry, without bar and
chain: 8.2 lbs. (3.7 kg)
Cutting attachment
3
)
Recommended cutting attachments in
compliance with Sec. 5.11 of ANSI
standard B 175.1-2000
Observe the information about ANSI
standard B 175.1-2000 as well as the
definition "low-kickback saw chain" in
the section "Safety Precautions and
Working Techniques".
Rollomatic E guide bars
STIHL reduced kickback guide bars
(with green label)
Bar lengths:
Pitch:
Groove width:
Sprocket nose:
Saw chains 3/8" P
STIHL reduced kickback saw chain
(with green label)
Picco Micro Comfort 3 (63 PMC3)
Pitch:
Drive link gauge:
Picco Super 3 (63 PS3)
Pitch:
Drive link gauge:
Picco Duro 3 (63 PD3)
Pitch:
Drive link gauge:
Chain sprocket
6-tooth for 3/8"P (spur chain sprocket)
12, 14, 16 in.
(30, 35, 40 cm)
3/8" P (9.32 mm)
0.50 in. (1.3 mm)
9-tooth
3/8" P (9.32 mm)
0.050 in. (1.3 mm)
3/8"P (9.32 mm)
0.050 in. (1.3 mm)
3/8"P (9.32 mm)
0.050 in. (1.3 mm)
MS 201 T