Sportplus SP-MR-020 Manual De Instrucciones página 30

Máquina de remo y giro
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Do not charge or use any tools to reactivate batteries. Do not dismantle, throw into
fire or short-circuit. There is a DANGER OF EXPLOSION!
Preferably use alkaline batteries, since they last longer than regular zinc-carbon
batteries.
A battery replacement is necessary as soon as the display starts to fade or fades
completely. Always replace all old batteries with new ones and make sure that the
batteries are inserted with the correct polarity.
Batteries could be fatal if swallowed. If a battery is swallowed, it may lead to
serious internal injury and death within 2 hours. For this reason, always store new
and depleted batteries as well as the product out of the reach of children. If you
suspect a battery has been swallowed or otherwise entered the body, seek medical
attention immediately.
If a battery leaks, avoid contact with skin, eyes and mucous membranes. In case of
acid contact, rinse the affected areas thoroughly with water and immediately seek
medical attention.
INFORMATION ON ASSEMBLY
The product should be carefully assembled by a responsible adult. Ask for the
assistance of another, technically-skilled person in case of doubt.
Before beginning assembly of the product, read all assembly steps carefully and
review the diagram.
Remove all packaging materials and lay out all the parts. This will give you a
good overview and simplify assembly. Shield the assembly surface from filth and
scratching by laying down suitable padding.
Check the components against the components list to make sure all are present.
Do not dispose of all packaging materials until assembly is completed.
Please note that there is always a risk of injury when using tools to carry out
manual tasks. Therefore, please exercise caution when assembling this product.
Make sure your work environment is hazard-free. For example, do not leave any
tools lying around.
After assembling the product according to the instructions, make sure that all
screws, bolts and nuts are installed correctly and tightened.
If necessary, lay out protective padding (not included) beneath the product to
protect your floor as there is no guarantee that, for instance, the rubber feet will not
leave marks behind.
SP-MR-020-V04-INT.indb 30
30
27/5/2019 1:00 PM

Publicidad

Tabla de contenido
loading

Tabla de contenido