Before Connecting Components - Yamaha YSP-3000 Manual De Instrucciones

Connections

Before connecting components

Cables used for connections
Audio/Video
A
HDMI cable
Audio
Audio pin cable (supplied)
(White)
(Red)
Optical cable (supplied)
Digital audio pin cable (supplied)
(Orange)
3.5 mm stereo mini plug cable
5
Subwoofer pin cable
OSD video pin cable (supplied)
(Yellow)
Notes on connecting the optical cable
• Pull out the cap before connecting the optical cable.
When you are not using the optical cable, be sure to put
the cap back in place.
• When inserting the cable into the optical digital jack,
make sure the direction is correct.
Cap
20
En
(White)
(Red)
(Orange)
Video
(Yellow)
Affixing cables
To prevent cables from becoming unplugged, place the
supplied cable clamp with the open side facing upward,
attach it to the rear panel of this unit in a suitable position,
and then affix cables in the cable clamp.
Information on HDMI™
Audio Signals
Input source
DVD video
DVD audio
Blu-ray Disc
HD DVD
Notes
• When CPPM copy-protected DVD audio is played back, video
and audio signals may not be output depending on the type of
DVD player.
• This unit is not compatible with HDCP-incompatible HDMI or
DVI components.
y
• We recommend that you use an HDMI cable shorter than 5 m
(16 ft) with the HDMI logo printed on it.
• Use a conversion cable (HDMI jack
this unit to other DVI components.
Priority order for audio input signals
When multiple types of audio signals are simultaneously
being input from a single source component, this unit
plays back the audio signals in the following priority
order: HDMI → Digital → Analog
As default settings, the following input jacks are assigned
to the corresponding input sources:
Input
jack
HDMI
Input
source
TV/STB
DVD
AUX 1
AUX 2
AUX 3
Optical cable
Attach to this unit
Audio signal type
Dolby Digital, DTS, PCM
2-channel stereo
(up to 96 kHz/24 bit)
Dolby Digital, DTS, PCM
↔
DVI-D jack) to connect
Digital Analog