MANUAL SETUP
BEAM MENU
Use to manually adjust the various parameters related to
the sound beam output.
SET MENU → MANUAL SETUP → BEAM MENU
2)BEAM MENU
.
A)SETTING PARAMETERS
B)BEAM ADJUSTMENT
C)IMAGE LOCATION
[ ]/[ ]:Up/Down
[ENTER]:Enter
y
You can adjust the sound beam output level of each channel in
"Adjusting the audio balance" (see page 84).
SETTING PARAMETERS
(Setting parameters)
Use to set the position of this unit in your listening room
and the distance of this unit from the listening position.
When you make settings for each parameter, other related
parameters are automatically adjusted to best match your
listening environment.
Note
If you make adjustments in SETTING PARAMETERS, the beam
optimization settings made in the AUTO SETUP procedure will
be lost. If you want to keep the beam optimization settings made
in the AUTO SETUP and make further adjustments, adjust
settings in BEAM ADJUSTMENT first (see page 75).
A)SETTING PARAMETERS 1/3
.
INSTALLED POSITION
;;;;;;;FLAT TO WALL
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
[ENTER]:Return
INSTALLED POSITION
(Installed position of this unit)
Use to adjust the installed position of this unit.
Choices: FLAT TO WALL (Parallel to wall installation),
ANGLE TO WALL OR CORNER
(Corner installation)
74
En
p
FLAT TO WALL
• Select FLAT TO WALL if this unit is installed in
parallel with the wall in your listening room. Adjust the
width and length of your listening room as well as the
distance of the listening position from this unit and the
distance of the center of this unit from the left wall.
Listening position
from the left wall
Room length
Room width
Choices for the room width and length:
2.0 m to 12.0 m (6.5 ft to 40.0 ft)
Choices for the listening position from this unit:
1.8 m to 9.0 m (6.0 ft to 30.0 ft)
Choices for the listening position from the left wall:
0.6 m to 11.4 m (2.0 ft to 38.0 ft)
Room width and
length
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
Listening position
from the unit and
the left wall
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
ANGLE TO WALL
OR CORNER
Listening position
from the unit
A)SETTING PARAMETERS 2/3
|
-------[ 5.4m ]-
|
4.9m
|
p
[ENTER]:Return
A)SETTING PARAMETERS 3/3
--------|
2.7m
[ 2.5m ]
|
p
[ENTER]:Return