Setting The Demo Mode - Yamaha YSP-3000 Manual De Instrucciones

3
Press / so that "TURN ON VOLUME" is
displayed in the front panel display.
ENTER
4
Press ENTER.
ENTER
5
Press / to adjust the initial volume level.
ENTER
Control range: MAX, 99 to 01, OFF
Control step: 1
6
Press STANDBY/ON on the remote control to
set this unit to the standby mode.
STANDBY/ON
The new setting for the maximum volume level will
be activated when you turn on the power of this unit
next time.
Adjusting the system parameters

Setting the DEMO MODE

You can test the sound beam output from this unit to
experience the sound beam.
1
Repeat steps 1 to 3 in "Using the system
parameters" on page 88.
2
Set the operation mode selector to YSP.
TV/AV
YSP
3
Press / so that "DEMO MODE" is
displayed in the front panel display.
ENTER
4
Press ENTER.
ENTER
91
En