SATA J Serie Manual Del Uso página 13

General safety warning of electric tool:
Warning
Read all warnings and instructions. Failure to follow the warnings listed below and instruction may result in electric
shock, fire and/or serious injury. Keep all warnings and instruction for review. "Electric tool" in all of the following
warnings refers to the electric tool driven by mains supply （ wired） or the battery （wireless） .
General safety warning of electric tool - workplace
1 ） Keep the work area clean and bright. Disordered and dark site may cause accidents.
2） Do not operate the electric tool in the explosive environment such as the flammable liquid, gas or dust. The spark generated by the
electric tool will ignite the dust or gas.
3） Operate the electric tool in the event of no children and bystanders around it. Inattention may cause the operator to lose control of
tool.
General safety warning of electric tool - electrical safety
1 ） Plug of electric tool shall be supported by the socket. Never modify the plug in any way. Any change-over plug shall not be used for
the electric tool to be grounded. Unmodified plug and corresponding socket will reduce the risk of electric shock.
2） Do not contact the grounded surface such as the pipe, cooling fin and refrigerator. If your body is grounded, the risk of electric
shock will increase.
3） Do not expose the electric tool to the rain or moisture. Water entering the electric tool will increase the risk of electric shock.
4） Do not abuse the wire. Never carry, pull the electric tool with wire or pull out its plug. Keep the electric tool away from heat source,
oil, sharp edges or moving parts. Damaged or entangled cords may increase the risk of electric shock.
5） For the outdoor application, an external cord for outdoor use shall be used. A cord suitable for outdoor will reduce the risk of
electric shock.
6） If it is inevitable to operate the electric tool in the humid conditions, the residual current device （ RCD） shall be used. RCD is able to
reduce the risk of electric shock.
General safety warning of electric tool - personal safety
1 ） Keep alert and awake when operating the electric tool. Do not operate the electric tool when you are tired or have medication,
alcohol or a therapeutic response. Instantaneous negligence in the operation of electric tool may result in serious personal injury.
2） Wear the personal protective equipment. Always wear the goggles. Safety devices, such as the dust mask, anti-slip safety shoes,
helmet, listening protection, etc., are able to reduce the personal injury.
3） Prevent the accidental starting. Make sure that the tool is switched off when connecting the power supply and/or battery box,
picking up or carrying the tool. Putting the finger on the switch which is powered on or inserting the plug when the switch is turned
on may result in the danger.
4） Remove all adjustment keys or wrenches before turning on the electric tool. A wrench or key left on the rotating part of electric tool
may cause the personal injury.
5） Do not stretch your hands excessively, and always pay attention to the foothold and body balance. This provides excellent control of
electric tool in unexpected situations.
6） Dress properly. Do not wear loose clothing or jewelry. Keep the clothes, gloves and hair away from moving parts. Loose clothes,
accessories or long hair may get caught in moving parts.
7） If a device for connecting the chip conveyor and dust collector is provided, make sure that they are connected well and used
properly. These devices are able to reduce the risk of dust.
51085
中文
EN DE RU KO PT JA ES
13