Setting The Video Signal; Av Input; Starting Procedure (For Av Source); Starting Procedure (For Camera) - Pioneer AVH-X491BHS Manual De Instrucciones

AUX source

Setting the video signal

When you connect this product to an AUX equipment, select the
suitable video signal setting.
The default setting is "Auto".
p You can operate this function only for the video signal input
into the AUX input.
1 Display the "Video Setup" screen.
2 Touch [Video Signal Setting].
3 Touch [AUX].
4 Touch the item.
The following items are available:
Auto, PAL, NTSC, PAL-M, PAL-N, SECAM.

AV input

You can display the video image output by the device connected
to this product.
 Refer to External video component and the display on page
54
CAUTION
For safety reasons, video images cannot be viewed while your
vehicle is in motion. To view video images, stop in a safe place
and apply the parking brake.
Starting procedure (for AV
source)
You can display the video image output by the device connected
to video input.
1 Display the "System" setting screen.
2 Touch [Input/Output settings].
3 Touch [AV Input].
Set the setting to "Source".
4 Display the "AV source selection" screen.
5 Touch [AV].
The image is displayed on the screen.

Starting procedure (for camera)

You can display the image output by the camera connected to
video input.
1 Display the "System" setting screen.
2 Touch [Input/Output settings].
3 Touch [AV Input] repeatedly, set to "Camera".
4 Display the "AV source selection" screen.
5 Touch [Camera View].
The image is displayed on the screen.
p When the camera view of both the rear view camera and 2nd
camera are available, the key to switch the display appears.
Touch this key to switch the display between the rear view
image and 2nd camera image.
Setting the video signal
When you connect this product to an AV equipment, select the
suitable video signal setting.
The default setting is "Auto".
p You can operate this function only for the video signal input
into the AV input.
1 Display the "Video Setup" screen.
2 Touch [Video Signal Setting].
3 Touch [AV].
4 Touch the item.
The following items are available:
Auto, PAL, NTSC, PAL-M, PAL-N, SECAM.
37