Bronpi VOLGA 130X40 Instrucciones De Instalación, Uso Y Mantenimiento página 26

Triple combustion
In Panamá series models, the regulation located under the door to the right of the ash pan, regulates both the double and triple combustion.
With this regulation open (regulation completely extracted, outside), it is possible to introduce hot oxygen twice into the combustion chamber,
thanks to itineraries designed by Bronpi. This combustion process makes the most of the calorific power of the
wood, while reduces the most harmful emissions as well as the consumption of wood.
Draft-diverter valve
The inserts of the Kenia, Madrid, Canadá series, and the Panamá series are provided with an adjustable draft-
diverter valve, with automatic opening that allows the control of the draw.
It is possible to place properly the draft-diverter valve when we open the door thanks to the screw on the
central higher of the frontal zone (turn right = open valve / turn left =close valve). The draft-diverter valve will be
opened automatically at the open of the door regardless of its position in order to avoid the exit of smoke to the
room (see drawing D13).
Baffle plate
The baffle plate is a fundamental part for the proper operation of the insert. It must be placed in the right position and the insert must not
be used without the baffle plate. This would invalidate the warranty.
WARNING!
The lack of the baffle plate causes an excessive draw. This causes a fast combustion, excessive wood consumption and
the overheating of the equipment.
Due to safety reasons during the transport, the baffle plate is not assembled. You will find it inside the combustion chamber. The correct
position should be the following one (see drawing D14).
Some models such as Volga, Londres and Bristol have a double baffle-plate which the same function (see drawing D15).
Mod. Londres and Volga
1
"Cold hands" handle
(Only model: Bristol)
Inside the ash pan you will find the "cold hands" handle in order to open the door. To
place it properly, it is necessary to introduce it from top to bottom and, later, rotate it
(see drawing D16).
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D15
2
25
Mod. Bristol
D13
D14
D16
INSERTS