Switching On/Off - Eschenbach mobilux DIGITAL Inspection Manual De Instrucciones

Switching on/off

Press and hold the On/Off button (w) for one second to turn on mobilux DIGITAL In-
spection and to switch to live image mode. The enlarged image of the test object will
appear on the display (q).
3 icons appear on the upper edge of the screen for approx. 2 seconds to indicate the
battery charge level, the last-configured zoom factor and the display brightness:
Battery fully charged
25% charge
To switch the device off, press and hold the On/Off button for one second. The current
zoom, screen mode and brightness settings will be saved.
To prolong the battery charge in the internal battery, the mobilux DIGITAL Inspection
switches off automatically if it is not moved for more than 5 minutes. If you want to
use the testing device again after this time, switch it on again.
Testing with the device
Switch the mobilux DIGITAL Inspection on and then place the device so that its con-
tact surfaces (d) are resting on the item to be tested. Start the test.
Saving the live image as a file
If you briefly tap the display when the testing device is switched on, three icons will
appear on the right-hand edge of the screen:
icon for the 'Save live image as file' (screenshot)
icon for 'Set zoom'
icon for 'Device settings'
Tap briefly on the
rently inserted in the testing device. The saved image is then shown on the display.
The screenshots are numbered sequentially. Tap the
mode. Tap the display briefly to hide the three icons.
Tip: If there is no SD card in the testing device when you tap the
memory card" message will be displayed.
icon to save the current live image as a file on the SD card cur-
75% charge
Battery empty
icon to return to live image
- 20 -
Operation
50 % charge
icon, the "No