Oster BLSTDP-W00 Manual De Instrucciones página 2

Ocultar thumbs Ver también para BLSTDP-W00:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

I Mp ORtA Nt sA F EG U AR D s
When using electrical appliances, basic safety precautions should always
be followed, including the following:
• Verify that the voltage in your home corresponds to that of your appliance.
• To protect against risk of electrical shock, do not put cord, plug, base, or motor in water
or other liquid.
• Unplug cord from outlet when not in use, before putting on or taking off parts and
before cleaning.
• Avoid contact with moving parts.
• Do not operate any electrical appliance with a damaged cord or plug or after the
appliance malfunctions or has been dropped or damaged in any manner. Return
appliance to nearest Authorized Oster
repair, mechanical repair, or adjustment.
• The use of attachments, including canning jars, not recommended by the manufacturer
may cause a risk of injury to persons.
• Do not use outdoors.
• Do not let cord hang over the edge of a table or counter or touch hot surfaces,
including the stove.
• Keep hands and utensils out of container while blending to reduce the risk of severe
personal injury and/or damage to blender. A rubber spatula may be used but must be
used only when blender is not running.
• Do not use a broken, chipped or cracked blender jar.
• Do not use broken, cracked or loose cutting blades.
• To reduce the risk of injury, never place cutting unit blades on base without jar properly
attached. Blades are sharp, handle with care.
• Always operate blender with cover in place.
• When blending hot liquids, lift and keep the flap located on the lid open. Do not fill
blender container beyond halfway. Always begin processing at the lowest speed
setting. Keep hands and other exposed skin away from the cover opening to prevent
possible burns. Jar will become hot from hot contents.
• Screw on blade assembly firmly. Injury can result if moving blades accidentally become
exposed.
• Do not leave blender unattended while it is operating.
• To disconnect cord, turn the blender off " ", and then remove the plug from wall
outlet.
• If jar is cracked, do not use. It could break during operation.
Service Center for examination, electrical
®
English-1

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Blstdg-b00

Tabla de contenido