Hints For Best Use - Oster BLSTDP-W00 Manual De Instrucciones

• Processing hot foods or liquids in the blender may cause hot liquid to spurt out when
the cover is removed. Always lift the snap-open spout located on the lid before blend-
ing hot foods or liquids. WARNING: When you work with HOT LIQUIDS, flip the jar lid
open and start at a low speed, and gradually increase to a faster speed. Do not add
liquid over the 1.0-liter/4 cup level. Always keep hands and exposed skin away from
steam. Start blending at lowest speed. Jar will become hot from hot contents. (Please
review Important Safeguards section.)
• To add liquids and small ingredients when blender is operating, lift the snap-open spout
and add ingredients through the opening.
• If blending action stops during blending or ingredients stick to the sides of the jar,
turn blender off. Remove the cover and use a rubber spatula to push mixture towards
blades.
• If using your blender to make salsa or other recipes using tomatoes, onions and other
vegetables, you may have better results using a slower speed function or the pulse
function.
• Do not try to mash potatoes, mix stiff dough, whip egg whites, grind corn,
raw meat or extract juices from fruits and vegetables. The blender was not
made to perform these tasks.
• Avoid bumping or dropping the blender.
MAINtAINING YOUR BLENDER
HoW to CLEAn tHE bLEnDER
• Unplug the blender from electrical outlet.
• Wipe blender base, control panel, and cord with a damp cloth or sponge.
To remove stubborn spots, use a mild, non-abrasive cleanser.
• To clean jar, unscrew the bottom cap, keeping jar tilted, so as not to drop
blade assembly while bottom cap is removed.
• Remove the blade assembly. Tilt blade slightly to properly remove.
• Carefully remove gasket from outer rim of blade assembly.
• Carefully wash blade assembly, gasket, jar and cover in warm, soapy water. Rinse and
dry thoroughly. Do not immerse the base in water.
• Place gasket onto blade assembly and re-insert blade assembly into glass jar. Do so
by tilting it slightly to enter into the bottom opening of the jar.
Move as needed to clear the remaining blades.
• Screw the bottom cap back onto jar in order to secure blade assembly and
place jar back onto motor base.

HINts FOR BEst UsE

English-6