Operation - Dexter 20VCIS2-165.1 Manual De Instrucciones

FR FR

5. OPERATION

ES ES
PT PT
WARNING: Always remove battery pack before changing or removing accessories. Only use
accessories specifically recommended for this tool. Others may be hazardous.
IT IT
INSTALLING/REMOVING BATTERY PACK
To install:
EL EL
Insert the battery pack.
Push battery pack into the bottom of the handle and that battery pack is secured in the product
PL PL
before beginning operation.
To remove:
Depress the battery pack unlock button and by pulling the battery pack out.
RU RU
For complete charging instructions, see the operator's manuals for your battery pack and charger.
UA KZ
LOCK-OFF BUTTON
The lock-off button is located on the handle above the switch trigger. You must depress the lock-off
button in order to pull the switch trigger. The lock resets each time the trigger is released.
UA KZ
NOTE: You can depress the lock-off button from either the left or right side.
RO RO
SWITCH TRIGGER
To turn the grinder ON, depress and hold lock-off button, then depress the switch trigger. To turn it
BR BR
OFF, release the switch trigger.
KICKBACK
EN
EN
Kickback occurs when the blade stalls rapidly and the saw is driven back towards you. Blade stalling
is caused by any action which pinches the blade in the wood.
DANGER: Release switch immediately if blade binds or saw stalls. Kickback could cause you to
lose control of the saw. Loss of control can lead to serious injury.
To guard against kickback, avoid dangerous practices such as the following:
Set blade depth incorrectly.
Saw into knots or nails in workpiece.
Twist the blade while making a cut.
Making a cut with a dull, gummed up, or improperly set blade.
Support the workpiece incorrectly.
Force a cut.
Cut warped or wet lumber.
Operating the tool incorrectly or misusing the tool.
To lessen the chance of kickback, follow these safety practices:
Keep the blade at the correct depth setting.
Inspect the workpiece for knots or nails before cutting.
364