Gps Tracker; Start Up - Husqvarna HTC T6 Manual De Usuario

Ocultar thumbs Ver también para HTC T6:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HTC DURATIQ
Grinding
Set the grinding speed using the knob (10). The set value
can be seen on the display.
Set the propulsion speed using the knob (11). The set value
can be seen on the display.
Choose direction of rotation (12) for grinding. The machine
starts grinding.
Select driving direction with the lever FWD/REV (13).
Control the speed (15) as needed. Can increase 2x and
change direction at the same speed as max.
Adjust the offset for grinding using the knob (14) as needed.

7.3 GPS Tracker

7.3.1 Start Up

1 Start up outdoors so the GPS tracker has free sight for positioning.
2 Start the grinding machine with the
3 Remove the GPS tracker (1) from the holder and push in the voltage cable (2) at the
same time as the cover comes loose (3).
4 Start the GPS tracker by moving the power switch (4) on the GPS tracker to position 1.
Wait until the green diode (6) lights up. Start up can take up to 30 seconds.
5 Replace the cover (3) making sure at the same time that it seals.
6 Replace the GPS tracker in the holder on the grinding machine. Make sure that the
cabling is not lying against a cooling flange or fan.
48
On/Off
button.
Accessories
D002998, 02.00

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Htc rt6Htc x6Htc rx6

Tabla de contenido