Sime MURELLE HE ErP Serie Manual Del Usuario página 110

ANOMALIES AND SOLUTIONS
When there is a functioning anomaly, the
display shows an alarm and the blue lumi-
nous bar becomes red.
Descriptions of the anomalies with the rela-
tive alarms and solutions are given below:
– ALARM 02 (fig. 27/a)
If the pressure detected by the transdu-
cer is lower than 0.5 bar, the boiler
stops and the display shows the alarm
"ALL 02".
Bring the pressure back to normal by
acting on the loading knob. Lower the
knob and turn it anti-clockwise to open
until the pressure indicated by the
display is between 1 and 1.5 bars.
WHEN FILLING HAS BEEN COMPLETED,
CLOSE THE KNOB BY TURNING IT
CLOCKWISE.
If it is necessary to repeat the system
loading procedure, it is advisable to
contact qualified technical personnel
to check the seal of the heating system
(to check whether there are any leaks).
OPEN
APRE
– ALL 03
Request assistance from qualified
technical personnel.
– ALL 04
Request assistance from qualified
technical personnel.
– ALL 05
Request assistance from qualified
technical personnel.
– ALL 06 (fig. 27/c)
Press the key f the controls (2) to
re-start the boiler.
If the anomaly persists, request assi-
110
stance from qualified technical person-
nel.
2
– ALL 07 (fig. 27/d)
Press the key
re-start the boiler.
If the anomaly persists, request assi-
stance from qualified technical person-
nel.
2
Fig. 27/a
– ALL 08
Request assistance from qualified
technical personnel.
– ALL 09
Request assistance from qualified
technical personnel.
– ALL 10
Request assistance from qualified
technical personnel.
– ALL 13 (fig. 27/e)
Press the key
re-start the boiler.
If the anomaly persists, request assi-
stance from qualified technical person-
nel.
Fig. 27/c
of the controls (2) to – ALL 14
Request assistance from qualified
technical personnel.
– ALL 15
Request assistance from qualified
technical personnel.
– From "ALL 20" to "ALL 29"
Request assistance from qualified
technical personnel.
GAS CONVERSION
If it is necessary to change to a different
type of gas, request assistance only from
authorised technical personnel.
MAINTENANCE
Annual maintenance of the appliance
should be planned sufficiently in advance,
requesting the assistance of authorised
technical personnel.
Fig. 27/d
DISPOSAL OF THE EQUIPMENT
(EUROPEAN DIRECTIVE 2002/96/CE)
Once it reaches the end of its operating life,
the equipment MUST BE RECYCLED in line
with current legislation.
IT MUST NOT be disposed of together with
urban waste.
It can be handed over to recycling centres,
if there are any, or to retailers that offer
this service.
Recycling prevents potential damage to the
environment and health. It allows to reco-
ver a number of recyclable materials, with
considerable savings in terms of money
and energy.
of the controls (2) to
2
Fig. 27/e