Assembling The Accessories; Glass Turntable; Metal Rack; Electrical Connection - Caso MG20 Manual Del Usuario

Tabla de contenido

Idiomas disponibles

13.6 Assembling the accessories

► The device can be operated with glass turntable or with glass turntable and metal rack.

Assemble the glass turntable as follows:

 Insert the glass turntable so the groove on the underneath side of the glass turntable

catch in the drive shaft.

► When operating the grill, the metal rack can also be used in order to grill the food evenly

as a result of the rotation.

 Insert the metal rack onto the glass turntable.

In order to ensure the safe and trouble-free operation of the device, the following

instructions must be observed for the electrical connection:

 Before connecting the device, compare the connection data (voltage and frequency)

on the rating plate with those of your electrical network. This data must agree in order

that no damages occur in the device. If in doubt, ask your qualified electrician.

 The connection between the device and the electrical network may employ a 3 meter

long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs

or gangs is prohibited because of the danger of fire that is involved with this.

 Make sure that the power cable is undamaged and has not been installed under the

device or over hot or sharp surfaces.

 The electrical outlet must be protected by a 16A safety cut-out switch, separately from

other electricity consumers.

 The electrical safety of the device is only guaranteed if the device is connected to a

properly installed protective conductor system. If in doubt, have the house installation

checked over by a qualified electrician. The manufacturer cannot be made responsible

for damages that are caused by a missing or damaged protective conductor.

This chapter provides you with important safety notices on the design and function of the

device.

Please note

 Insert the rolling ring.

Tabla de Contenido

Tabla de contenido