Opening / Closing Door; Switch On/Off Sound; Activation After Selecting The Programme; Quick Start - Caso MG20 Manual Del Usuario

15.4 Opening / closing door

 Open door
Pull the door handle with a slight tug to open the door of the device. If the device is switched
on, the current cooking programme will be interrupted.
► Leave the door open for a moment before reaching into the cooking chamber, to allow the
accumulated heat to escape.
 Close doors
Close the door using the door handle until the door latch audibly locks in place.
If a current cooking programme was interrupted as a result of opening the door,
the current cooking programme will be continued after pressing the button
Start/Quickstart.

15.5 Switch on/off sound

Press the button Power/sound for three seconds in order to switch on or off
the sound (beep tone).
You can hear messages of the programme ending and warning signals even if
the sound has been switched off.

15.6 Activation after selecting the programme

After selecting the program, press the button Start/Quickstart, to start the
preset cooking programme.

15.7 Quick start

Utilise this function to programme the device for comfortable cooking at 100%
microwave performance. Press the Start/Quickstart button in quick sequence
to set the cooking time. The device starts automatically after 2 seconds.
Once the end of the cooking time is reached, three signal tones will be emitted
and END will appear in the display.

15.8 De-activation:

In order to interrupt an ongoing cooking programme, you can proceed as
follows:
Pres the Stop button once. The cooking programme that is in use will be
stopped.
Open the door of the device. The cooking programme that is in use will be
stopped.
► To continue the interrupted cooking program, press the button
Start/Quickstart after closing the door.
Please note
Please note
59