Required accessories and tools
Supplied accessories
–
Installation instructions
–
Operating instructions
–
Installation kit
Optional accessories
Installation accessories for Side-by-Side installation
For permanent connection of two individual appliances,
e.g. Freezer next to Refrigerator.
Lateral additional heating
If the gap between the appliances is less
than 6" (160 mm).
Connecting element for furniture doors
For connection of two door panels (see explanation in
Section "4. Preparing the furniture doors"). Can be used
for standard height door panels without further
preliminary work.
Miscellaneous
–
Stepladder
–
Dolly, hand truck
–
Hammer drill for drilling holes in wall or floor
–
Bits according suitable for material and in different
sizes
–
Wooden beam (cross section min. 3" x 4") as an
alternative tip protection, length according to the
width of the installation niche
–
Wooden screws in different sizes
–
Thin plywood sheet, particle board or cardboard to
protect the floor from damage
–
Suitable material for covering and protecting
furniture (e.g. protective sheets)
–
Adhesive tape
Note:
Before using, check whether the removed adhesive
tape leaves adhesive residue on the work surfaces!
Otherwise do not use on high-quality work surfaces.
Tools
Cordless screwdriver
T20 Torx-bit magnetic
holder
T20 Torx screwdriver
5
/
" (8 mm) socket
16
wrench
Various size drills
1
Open end wrench
/
"
2
(SW 13 mm)
Multigrip pliers
Adjustable wrench
Cutter with adjustable
blade
Metal tape measure,
folding ruler
Square
2' (60 cm) and 4' (1 ,2 m)
spirit levels
Level, min. 4' (1 ,2 m) long
11