Important Safety Instructions - Gaggenau RB 492 Instrucciones De Instalación

Important Safety Instructions

These mounting instructions are designed to help you
install your new appliance.
The manufacturer cannot be held liable for mounting
which has been improperly carried out. We recommend
that you allow a qualified specialist to set up and switch
the appliance on for the first time.
Following all information and keeping to the instructions
are preconditions for mounting and switching the
appliance on safely for the first time.
Keep the mounting instructions safe for use later on.
Before setting up and switching the appliance on for the
first time, read the mounting instructions fully and
thoroughly.
ã WARNING
These appliances are top-heavy and must be
secured to prevent the possibility of tipping forward.
Anti-tip protection is required.
Keep doors closed until the appliance is completely
installed and secured per installation instructions.
Due to the weight and size of this appliance, and to
reduce the risk of personal injury or damage to the
product – TWO PEOPLE ARE REQUIRED FOR
PROPER INSTALLATION.
This appliance must be properly grounded. See the
section on "Connecting the power".
Use this appliance only for its intended purpose.
Immediately repair or replace electric service cords
that become frayed or damaged.
Unplug the appliance or switch off the fuse before
cleaning or making repairs.
Repairs should be made by a qualified service
technician.
ã CAUTION
Installation of this appliance requires basic
mechanical, carpentry and plumbing skills.
Proper installation is the responsibility of the
installer.
Product failure due to improper installation is not
covered under the Appliance Warranty.
See the Owner's Manual for warranty information.
6
Important
Save these instructions for local inspector's use.
Observe all governing codes and ordinances.
Note to Installer – Be sure to leave these instructions
with the Consumer.
Note to Consumer – Keep these instructions with your
Owner's Manual for future reference.
General
These installation instructions are intended for use by
qualified installers. All connections for water, electrical
power and grounding must comply with local codes and
ordinances and be made by licensed personnel when
required. In the absence of a local code:
– In the U.S.A., in accordance with the National
Electric Code, ANSI/NFPA70 – latest edition/State
and Municipal codes and/or local codes.
– In Canada, in accordance with the Canadian Electric
Code C22.1 – latest edition/Provincial and
Municipal codes and/or local codes.
Definitions
ã
WARNING
This indicates that death or serious injuries may
occur as a result of not observing this warning.
ã
CAUTION
This indicates that minor or moderate injuries or
damage may occur as a result of not observing
this warning.
Note:
This is used to draw the user's attention to something in
particular.