Switching Between Modes; Harness To Booster Mode: Storing The Harness And Buckle - Britax PIONEER Guia Del Usuario

Before you begin:
IMPORTANT: It is not necessary to remove the harness to use this
seat in booster mode. To store the harness, follow the instructions
below. If you wish to remove, follow the instructions on pg. 32.

Harness to Booster Mode: Storing the Harness and Buckle

Loosen the harness
1
completely.
a Press release lever
b Pull both harness straps forward
Open the chest clip.
2
a Press tabs
b Pull apart
Release the harness buckle
3
and place the harness straps
around the armrests.
Pull seat cover forward.
4
Unhook the elastic bands at
5
the back of the seat cover. Pull
the seat cover and foam insert
forward and slide over the belly
pad.
Lay the belly pad forward and
6
position on top of the harness
adjuster release lever.

Switching Between Modes

29