Weber SUMMIT S-660 Guia Del Propietario página 191

CONNECT GAS SUPPLY
A 58 inch (147.32 cm) corrugated gas line is connected to the manifold of the grill.
A) The main corrugated line passes through the "island" structure cavity to the bulk
head and regulator connection inside the tank enclosure (1).
B) Uncap the flare fitting from the T-Connection on the bulk head and regulator
connection (2).
C) Connect the main corrugated hose to the T-Connection on bulkhead fitting. Use the
" (12.7 mm) inch flared gasket to ensure proper seal (3).
⁄
1
2
If you choose to use rigid pipe, semi-rigid tubing, and/or a connector other than the one
supplied, the connector must comply with the Standard for Connectors for Outdoor Gas
Appliances and Manufactured Homes, ANSI Z21.75*CSA 6.27, and be suitable for outside
installation.
The length of this connector must not exceed 58" (147cm) due to a pressure drop that
will occur affecting the performance of the grill.
28
GAS SUPPLY CONNECTION
◆
CONNECTION CHART
1
1
5
7
2
3
10
9
8
4 Typical natural gas pipe routing
5
6
Gas line and regulator connected
7
Connecting corrugated gas line to the regulator
8 Hard piped gas supply
9 Cap (optional side burner)
10
4
4
6
10
9
8
Side view
Regulator